DFT mechanistic study of the H2‐assisted chain transfer copolymerization of propylene and p‐methylstyrene catalyzed by zirconocene complex

DFT computations have been performed to investigate the mechanism of H₂‐assisted chain transfer strategy to functionalize polypropylene via Zr‐catalyzed copolymerization of propylene and p‐methylstyrene (pMS). The study unveils the following: (i) propylene prefers 1,2‐insertion over 2,1‐insertion both kinetically and thermodynamically, explaining the observed 1,2‐insertion regioselectivity for propylene insertion. (ii) The 2,1‐inserion of pMS is kinetically less favorable but thermodynamically more favorable than 1,2‐insertion. The observation of 2,1‐insertion pMS at the end of polymer chain is due to thermodynamic control and that the barrier difference between the two insertion modes become smaller as the chain length becomes longer. (iii) The pMS insertion results in much higher barriers for subsequent either propylene or pMS insertion, which causes deactivation of the catalytic system. (iv) Small H₂ can react with the deactivated [Zr]?pMS?PP_n facilely, which displace functionalized pMS?PP_n chain and regenerate [Zr]? H active catalyst to continue copolymerization. The effects of counterions are also discussed. © 2014 Wiley Periodicals, Inc. J. Polym. Sci., Part A: Polym. Chem. 2015 , 53, 576–585     

双掺(Tm3+,Tb3+)LiYF4激光器1.5 μm波长激光阈值分析

由速率方程推出了双掺（Tm^3 ,Tb^3 ）离子准四能级系统的激光阈值解析式，讨论了Tm^3 和Tb^3 离子之间的相互作用。分析了1.5μm波长附近的激光阈值和Tm^3 、Tb^3 离子的掺杂原子数分数及晶体长度的关系。结果表明，对于对应Tm^3 离子^3H4→^3F4跃迁的约1.5μm波长的激光，激活离子Tm^3 的掺杂原子数分数过大时，交叉弛豫作用将使系统阈值迅速增加。Tb^3 离子的加入，一方面能抽空激光下能级，起到降低阈值的作用；另一方面亦减少了激光上能级的寿命，使阈值升高。故Tb^3 离子有最佳掺杂原子数分数。对于Tm原子数分数为y=0.01的Tm:LiYF4晶体，Tb^3 离子的最佳掺杂原子数分数为0.002左右，同时表明，激光阈值与晶体长度有关。最佳晶体长度与Tm^3 、Tb^3 离子的掺杂原子数分数以及晶体的衍射损耗和吸收损耗有关。     

微球动态涂敷状态实时监测光学系统的设计

 介绍了一种可用于实时监测直径0.2～1.0 mm激光核聚变靶球涂敷状态的光学系统的设计，系统采用环形LED照明系统以适合特殊的照明要求，用Petzval型物镜使500 mm处的微球清晰成像于CCD像面上，CCD输出的图像电信号经图像采集卡转换成数字信号，最后该数字信号由计算机进行处理，实现了系统对靶球膜层涂敷作业的自动监控，大大提高了涂敷效率。所设计的系统轴上点最大弥散斑直径为12.6 mm,轴外最大弥散斑直径为15.8 mm，整个视场的像质比较均匀,分辨率较高，对于波长522 nm的光线，场曲和畸变分别小于15 mm和0.012%，像质优良。     

一种基于数字全息技术的盲音频水印算法

提出了一种基于数字全息技术的盲音频水印算法.水印图像经随机相位调制形成物光波,该物光波的傅里叶变换与参考光波发生干涉,形成傅里叶变换全息图.再利用离散余弦变换的能量压缩能力,通过量化算法把降维的水印,即傅里叶变换全息图嵌入音频信号中,在水印提取过程中不需要原始音频信号的参与.仿真实验表明,该算法对低通滤波、噪音干扰特别是剪裁具有一定的稳健性.     

高温超导带材交流损耗的数值计算与分析

高温超导带材在许多领域得到越来越广泛的应用。交流损耗计算对于高温超导带材具有重要意义。该文介绍了两种交流损耗的数值计算模型,并以其中一种模型为例,对带材的交流损耗进行计算,与Norris公式计算结果作了比较,证明结果有效。最后提出了交流损耗数值计算中存在的问题。     

40Ar+238U 实验介绍

主要介绍了利用兰州重离子加速器提供的270 MeV的40Ar离子束轰击238U靶，通过熔合蒸发反应进行试合成Z=110附近的新同位素的实验情况。分析了目前关于超重核研究的现状并描述了这次实验的目的、 可行性分析、 实验装置以及实验过程等。本次实验仍然用氦喷嘴技术对产物进行传输， 并用一套具有数对探测器组的转轮收集探测系统对产物进行收集和测量。 The state of the experiment to produce the new isotopes around Z=110 are presented in this paper. The emphasis is laid upon introducing the experiment purpose, the set up and the feasibility for producing this objective nuclide. In the experiment the new isotopes were produced by the complete fusion evaporation reaction of 238U with 270 MeV 40Ar at the Sector Focus Cyclotron (SFC) of Heavy Ion Research Facility in Lanzhou(HIRFL). The reaction products were also transported and collected by using the helium jet technique and rotating wheel apparatus.     

A Facile Synthesis of α-Phenylthio-α,β-Unsatuated Esters

α-phenylthio-α，β-unsaturated esters 6 were synthesized by Witting reaction of 3.which were prepared by a phenylsulfenyllation-trans-ylidation reaction.     

多媒体在二维动量实验中的应用

利用VisualBasic的多媒体功能和CCD摄像头以及气垫桌等组成的实验系统，演示了二维碰撞中的动量守恒．